After replacing my 2019 13-inch MBP display I tested it before putting about four more screws in. I disabled auto boot before I even started this process. I plugged the battery connectors in and then loosely put back the lower case without putting in the screws. It booted up with the power adapter connected and was able to access my login screen.
I put in the remaining screws and installed the screws in the lower case of the laptop. Now I don't get any power even with the power adapter connected. I went back in and disconnected the battery cable and then reconnected it. Still no power.
Any suggestions on either what might have gone wrong or suggestions on getting the laptop to power up is appreciated.
I put in the remaining screws and installed the screws in the lower case of the laptop. Now I don't get any power even with the power adapter connected. I went back in and disconnected the battery cable and then reconnected it. Still no power.
Any suggestions on either what might have gone wrong or suggestions on getting the laptop to power up is appreciated.
