Become a MacRumors Supporter for $50/year with no ads, ability to filter front page stories, and private forums.

steffi

macrumors 6502a
Original poster
Jun 7, 2003
866
12
Is there a good way to take care of this. I do have a Dyson available.
 
It's just like when your Ferrari gets dirty... you buy a new one!


I take the computer outside and use compressed air to blow it out. I figure blowing it out in place just means the dust gets right back in more quickly.
 
If you use compressed air, be sure to keep the can upright and don't jiggle the can.... you may get liquid spurting out otherwise.

I have my Mac Pro sitting on a couple of 4 inch blocks (1 block for each end, not stacked up). Just that little bit of height can make a huge difference to the dust and smurf that gets sucked up....
 
When using compressed air be sure to hold the fan blades still.

A vacuum cleaner is a dangerous way to clean a computer. I wouldn't suggest that method.

It's fine if you know what you are doing. I use a vacuum most of the time. Although I know what can and can not be touched.
 
Is there a good way to take care of this. I do have a Dyson available.

Get it up off the floor; no sense ruining a $2500 computer for want of a $250 desk. Otherwise, vacuum the floor more often.

A vacuum cleaner is a dangerous way to clean a computer. I wouldn't suggest that method.

It's only dangerous if you break something off or build up static electricity. Keep the Mac plugged in and grounded while you're cleaning, and don't let the vacuum come anywhere near the logic board. Best not to use it at all inside the case. If you stick to the outside, you should be fine.

If you have a vacuum with a blower connection, use that.
 
Get it up off the floor; no sense ruining a $2500 computer for want of a $250 desk. Otherwise, vacuum the floor more often.



It's only dangerous if you break something off or build up static electricity. Keep the Mac plugged in and grounded while you're cleaning, and don't let the vacuum come anywhere near the logic board. Best not to use it at all inside the case. If you stick to the outside, you should be fine.

If you have a vacuum with a blower connection, use that.

You actually outlined my concerns there, small parts and static electricity. I'm quite cautious on things like computer cleaning advice.
 
Register on MacRumors! This sidebar will go away, and you'll see fewer ads.