I posted this as a reply elsewhere, figured I should make this a post here as well
So we all know about the percentage of battery life in settings, however what’s good enough?
In the aviation sector most all pilots have iPads (the mini is very popular) to use as EFBs, electronic flight bags, it has all our charts, company manuals, can preform landing and takeoff calculations, check weather on the ground etc, since EVERYTHING needs the FAAs approval many of us also have the minimum battery life before we are required to have the battery or device replaced
I thought some might be interested in this, so here it is
“Batteries in xxxx devices are not replaceable and require no maintenance. There is no recommended battery replacement interval nor are there recommended charging procedures.
Flight crews shall report any device that does not properly charge or discharge. Any reported device will undergo at lease full charge/discharge cycles utilizing the testing procedure below. If the unit does not satisfactorily test it will be sent to the manufacturer for repair or replaced.
Each device serving as an EFB will undergo routine battery testing every 12 months using the following procedure
Device configuration will be as follows:
Battery fully charged
Airplane mode: On
Wi-Fi: Off
Cellular Data: Off
Bluetooth: Off
Brightness: Maximum (unit's screen illuminated for duration of test)
Auto Lock: Off
Ambient temperature between 70 - 80 degrees Fahrenheit.
So we all know about the percentage of battery life in settings, however what’s good enough?
In the aviation sector most all pilots have iPads (the mini is very popular) to use as EFBs, electronic flight bags, it has all our charts, company manuals, can preform landing and takeoff calculations, check weather on the ground etc, since EVERYTHING needs the FAAs approval many of us also have the minimum battery life before we are required to have the battery or device replaced
I thought some might be interested in this, so here it is
“Batteries in xxxx devices are not replaceable and require no maintenance. There is no recommended battery replacement interval nor are there recommended charging procedures.
Flight crews shall report any device that does not properly charge or discharge. Any reported device will undergo at lease full charge/discharge cycles utilizing the testing procedure below. If the unit does not satisfactorily test it will be sent to the manufacturer for repair or replaced.
Each device serving as an EFB will undergo routine battery testing every 12 months using the following procedure
Device configuration will be as follows:
Battery fully charged
Airplane mode: On
Wi-Fi: Off
Cellular Data: Off
Bluetooth: Off
Brightness: Maximum (unit's screen illuminated for duration of test)
Auto Lock: Off
Ambient temperature between 70 - 80 degrees Fahrenheit.
- When the test is ready to begin the unit will be unplugged from its charging source and the time noted. Time will be noted again when the unit discharges to 50%.
Any unit discharging from 100% to 50% in under three hours will be sent to the manufacturer for repair or replacement. - Results will be tracked by the EFB Program Manager.”