Hello all, So i bought this imac from a friend. It had 12 GB of ram. 4x4 and then 2x2 below in the slots.
I decided to upgrade and had 2 spares of total 16gb in 2x4gb (8gb each) module. The specs are the right ones too from Mushkin.
I removed the exiting 2x2gb ram and put the 8gb ones in. So I should have 24gb with 4x4 on top and 8x8 bottom.
When I boot up, I still see the old config showing up as 4x4 and 2x2. I did the PRAM etc etc n still shows the original ram. Mind you it does boot up bit faster or seem to load onto desktop so not sure if something is amiss. I don't get any ram errors either.
I decided to upgrade and had 2 spares of total 16gb in 2x4gb (8gb each) module. The specs are the right ones too from Mushkin.
I removed the exiting 2x2gb ram and put the 8gb ones in. So I should have 24gb with 4x4 on top and 8x8 bottom.
When I boot up, I still see the old config showing up as 4x4 and 2x2. I did the PRAM etc etc n still shows the original ram. Mind you it does boot up bit faster or seem to load onto desktop so not sure if something is amiss. I don't get any ram errors either.