Mac Mini power supply voltage

[NCMau]

Mid 2010 Mini. No power. Done PMU reset several times. I removed the power supply and measured 11+ voltage from the first 4 pins of the connector to the logic board. I am hoping that the PS is defective and not the logic board.
1. Is this the correct voltage and should there be additional voltage from the other pins?
2. The on-board battery measure 2.6V. Could this low voltage cause my "no power" problem?

 

[AndyMacAndMic]

Why do you post this in the 'Alternatives to Mac Hardware' thread?

 

[NCMau]

Why do you post this in the 'Alternatives to Mac Hardware' thread?

Why do you post this in the 'Alternatives to Mac Hardware' thread?

Why do you post this in the 'Alternatives to Mac Hardware' thread?

[doublepost=1544464614][/doublepost]I posted this thread to the Alternative to Mac Hardware by error. I can't find a way to delete it. I reposted it to the proper one.

 

[AndyMacAndMic]

[doublepost=1544464614][/doublepost]I posted this thread to the Alternative to Mac Hardware by error. I can't find a way to delete it. I reposted it to the proper one.

OK. I just mentioned it because you will probably not get a lot of responses on your question in this thread