Sidebar Sidebar
Become a MacRumors Supporter for $50/year with no ads, ability to filter front page stories, and private forums.

RAM won't seat properly....

S

Samadams12

macrumors newbie
Original poster
Jan 1, 2013
3
0
Hi,

I'm new to the forum and registered to ask this question, sine I've googled and seached a ton and haven't found anything helpful.

I tried upgrading to 8GB ram last night, but the top one won't seat properly. The slot won't pop up, and can't slide it in at a 40 degree angle. The bottom one slid in like it should and I was able to press down and heard the click. But the top one will only go straight in lying flat down, and the gold connectors are still visible, it won't go all the way in.

Any suggestions? I tried pushing it in as hard as I dared without risking a break.
 
Samadams12 said:
Hi,

I'm new to the forum and registered to ask this question, sine I've googled and seached a ton and haven't found anything helpful.

I tried upgrading to 8GB ram last night, but the top one won't seat properly. The slot won't pop up, and can't slide it in at a 40 degree angle. The bottom one slid in like it should and I was able to press down and heard the click. But the top one will only go straight in lying flat down, and the gold connectors are still visible, it won't go all the way in.

Any suggestions? I tried pushing it in as hard as I dared without risking a break.
Click to expand...

I had a similar problem upgrading. All I can tell you is unless that little slot divider is broken (the part where the gold connectors insert), just use a bit of elbow grease. My bottom slot was a bit hard to push in, but I finally got it.
 
Last edited:
Samadams12 said:
Hi,

I'm new to the forum and registered to ask this question, sine I've googled and seached a ton and haven't found anything helpful.

I tried upgrading to 8GB ram last night, but the top one won't seat properly. The slot won't pop up, and can't slide it in at a 40 degree angle. The bottom one slid in like it should and I was able to press down and heard the click. But the top one will only go straight in lying flat down, and the gold connectors are still visible, it won't go all the way in.

Any suggestions? I tried pushing it in as hard as I dared without risking a break.
Click to expand...

Does the original module get into place without problems?
Have you tried swapping the modules? (I mean, trying to put the one that sits properly in the lower slot into the upper one).

Try putting the original modules again. Both of them. You know they'll fit so keep trying until you get it. I can recall finding it a little more difficult to put the second ram module.

The 45º angle isn't that obvious and you end up with several attempts. I also recall having to press a little harder than expected.

But yes, don't press too hard. Be gentle. It'll eventually get in.
 
Thanks guys, got it in finally. I just had to push harder. I was a little hesitant because it looks so fragile, but that's all it needed. Both slots are now recognized in Mac.

:)
 
You must log in or register to reply here.
Register on MacRumors! This sidebar will go away, and you'll see fewer ads.
Top Bottom
Back