I use a controller-based WLAN from ARUBA.
My SSID is configured to require company-wide WPA2 authentication (i.e. with username and password). The connection works fine if I manually connect to the SSID. I then choose to connect automatically. Now the iPhone doesn't do that.
Only if I have selected the option "Ask to join networks". Then the iPhone connects automatically. But I HATE this option, because if you go in a busy area, you get thousands of WLAN networks suggested, during writing a short message.
Therefore the question: How can you reach the automatic connection WITHOUT the option "Ask to join networks"?
My device: iPhone 8 plus with IOS 12.1.4
What I have already tried:
Every hint would be helpful, who have some advice?
ciao
ryder
My SSID is configured to require company-wide WPA2 authentication (i.e. with username and password). The connection works fine if I manually connect to the SSID. I then choose to connect automatically. Now the iPhone doesn't do that.
Only if I have selected the option "Ask to join networks". Then the iPhone connects automatically. But I HATE this option, because if you go in a busy area, you get thousands of WLAN networks suggested, during writing a short message.
Therefore the question: How can you reach the automatic connection WITHOUT the option "Ask to join networks"?
My device: iPhone 8 plus with IOS 12.1.4
What I have already tried:
- Network settings reset
- Mobile phone booted
- An iPad with also 12.4.1 - same problem
- With the Apple Configurator using profiles the WLAN stored
- The SSID is connected manually, not via broadcast.
- Tried with my MAC, V. 10.14.3 -- no problems at all
Every hint would be helpful, who have some advice?
ciao
ryder