It works with the 12 Pro Max, but just barely. You have to be very deliberate about how/where you lay it down. Mainly because the huge camera bump makes placement tricky. Not sure if that's been mentioned before. If you use a case, it's obviously even tougher.
I realised today that the camera bump was likely impacting me with my charger, this why earlier I reported it (Carved charger) not working and then revised my post today to say it was. I think the culprit is the camera bump.
The charger I was using is a rectangle shape. To date I have placed the charger in the same orientation as the phone. In attempting to have the phone sit flat I was placing it so the camera bump was hanging off the edge of the charger, but I think this was causing the Qi coil to be too low on the phone so it was misaligned. If I positioned it such that the charger and phone were both sitting in portrait orientation and the coils correctly overlapping, there was an air gap thanks to the bump on the 12 Pro Max case that hasn’t existed in past cases between the charger and phone. This likely reduces the chargers effectiveness. For that particular charger rotating it so the charger was in landscape but the phone in portrait orientation allowed more reliable contact as I could align the chargers better without having the camera bump creating an air gap.
I can imaging there will be a few chargers impacted by the new 12 Pro Max cases having a bump that adds extra spacing between the phone and the charger above and beyond what you get as a result of using a case. Probably not the only issue as the other models cases don’t have the same bump, but I assume it’s not helping charging efficiency for the Pro Max with certain chargers.
Last edited: